whevisual.blogg.se - Steyr mannlicher m

WARNE recommends the use of a REMOVABLE thread locking compound on base/rail installations only, for best results.WARNE recommends no more than *25 in/lb maximum torque.If base(s)/rail fit properly, firmly tighten screws.Using a T-15 wrench (supplied with WARNE rings) loosely install the supplied Torx 15 screws.If you have short and long screws, please use the short screws in the front of base/rail, front holes of firearm.In some instances the front base will overhang the receiver, place base overhang towards the rear of the firearm.Place the base(s)/rail on the receiver.

Remove all oil and grease from the holes in the receiver, the base screws and contact surfaces.

Visually inspect your firearm’s receiver for burrs around the screw holes and remove if necessary.

Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing. Always verify that your firearm is UN-LOADED before performing any service on it.